Circular Segments and Annular Sectors
Circular Segments and Annular Sectors
Circular Segments and Annular Sectors. Output order: angle α / θ, area G₁ / S, area G₂ / perimeter P
- 321 bytes
- COMP mode
Worked examples
Example 1
Find the angle and both circular segment areas from the radius and chord. M=1; r=10 cm; c=12 cm Find the requested quantities and show a mathematical derivation.
Answer
Standard solution (without a calculator)
- Build the mathematical model and substitute the data.
- α=2asin(12/20)≈73.73979529°; t=απ/180
- G₁=100(t−sin t)/2≈16.35011088 cm²
- G₂=100π−G₁≈297.8091545 cm²
Example 2
Find the shaded annular sector area and its entire boundary length. M=2; r=4 cm; R=9 cm; θ=200° Find the requested quantities and show a mathematical derivation.
Answer
Standard solution (without a calculator)
- Build the mathematical model and substitute the data.
- S=(200/360)π(9²−4²)=325π/9 cm²
- L_outer+L_inner=(200/180)π(9+4)=130π/9 cm
- P=130π/9+2(9−4)=10+130π/9 cm
Example 3
Treat the inner radius as zero. Recover the angle from the area and find the sector perimeter. M=2; r=0; R=15 cm; S=75π cm² Find the requested quantities and show a mathematical derivation.
Answer
Standard solution (without a calculator)
- Build the mathematical model and substitute the data.
- θ=360×75π/(π×15²)=120°
- S=75π cm²
- P=2×15+π×15×120/180=30+10π cm
When to use it
Read the conditions, choose the geometric model, then enter the values in the stated order. The program does not interpret a diagram or choose which regions to add or subtract.
Input order
- M=1: A=r (radius), B=c (chord length)
- M=2: A=r (inner radius), B=R (outer radius), C=θ (angle, °), D=S (area)
- Leave exactly one of θ and S blank.
- For an unknown field, press EXE without typing. A typed 0 is a known zero.
Output order
- angle α / θ
- area G₁ / S
- area G₂ / perimeter P
Conditions and limitations
- M=1: r>0; 0<c≤2r; 0<α≤180°
- M=2: 0≤r<R; 0<θ≤360°; S>0
- M=2: θ/S: #{EXE}=1; M∈{1,2}
- c<0.1r: ε_rel≤1.1×10⁻⁶
- Leave exactly one of θ and S blank.
- For an unknown field, press EXE without typing. A typed 0 is a known zero.
- Small segments use an approximation. Extreme scale or high-precision cancellation requires separate calculation.
- Radii so close that the calculator treats them as equal cannot be resolved reliably.
- For a full circle there are no straight radial boundary edges.
- Each new run may overwrite the working registers and Ans. Enter the known values again.
- Use Deg. Do not round intermediate values; retain exact π expressions in written work.
- Use one length unit; areas use its square. −1 is an error, never an area or a solution set.
Checking access…